Manage stand orders
Select Option

ELNA GmbH

Heidehofweg 22, 25499 Tangstedt
Germany
Telephone +49 4101 301-01
Fax +49 4101 301-333
info@elna.de

Submit your contact details

Provide your contact details to the exhibitor. Optionally, you may also add a personal message.

Please log in

You must be logged in to send the contact request.

An error has occurred

Please check your internet connection or try again later.

Message has been sent

Your message to the exhibitor was sent successfully.

Hall map

boot 2022 hall map (Hall 10): stand C17

Fairground map

boot 2022 fairground map: Hall 10

Our range of products

Product categories

  • 02  Engines and Related Equipment
  • 02.02  Engine Parts/Control
  • 02.02.28  Trim System/Trim Tabs
  • 03  Shipping/Yachting Equipment and Accessories
  • 03.01  Electric/Electric Systems
  • 03.01.06  Batteries/Accessories
  • 03  Shipping/Yachting Equipment and Accessories
  • 03.01  Electric/Electric Systems
  • 03.01.07  Battery Chargers
  • 03  Shipping/Yachting Equipment and Accessories
  • 03.01  Electric/Electric Systems
  • 03.01.08  Monitoring Systems/Alarms

Monitoring Systems/Alarms

  • 03  Shipping/Yachting Equipment and Accessories
  • 03.01  Electric/Electric Systems
  • 03.01.11  Renewable Energy/Solar Power Technology

Renewable Energy/Solar Power Technology

  • 03  Shipping/Yachting Equipment and Accessories
  • 03.01  Electric/Electric Systems
  • 03.01.16  Lightning Protection

Lightning Protection

Our products

Product category: Battery Chargers

Blue Sea BS 7604 BatteryLink Battery Charger

Blue Sea BS 7604 BatteryLink battery charger allows you to charge two batteries with or without shore connection with a multi-stage 10A charger and integrated 65A automatic charging relay (ACR).

MAIN FEATURES
Charge two batteries with or without shore power with a multi-stage 10A charger and integrated 65A automatic charging relay (ACR).
charge without shore power: You can charge two isolated battery banks using AC shore power with the three-stage 10A charger
charging with shore power: you can use the DC power of the alternator to charge both the starting and auxiliary battery through the integrated 65A ACR.
Battery temperature equalization extends battery life
Start isolation protects electronics from voltage drops
includes remote LED indicator for charge status at the wheel
insulating covers
one-piece, stainless steel flange nuts ensure a secure connection

TECHNICAL DETAILS
Output voltage: 10A
12V DC
Number of outputs: 1 negative
2 positive
Battery connection with torque limiter: 6.78 Nm
Continuous charge current: 65A
Peak charge current: 115A
Input voltage range: 90-265V AC
Frequency range: 50/60Hz
End of charge voltage: 13.5V DC typ.
Battery Types: AGM
Lead Acid
TPPL
Recommended Cable Thickness: 10 AWG Ground Cable
6 AWG Plus Cable
Max. Battery cold start current: 850CCA
Maximum cable thickness: 1/0 AWG (50mm)

More Less

Product category: Batteries/Accessories

Blue Sea BS 6005 Mini ON-OFF battery switch with key

Blue Sea BS 6005 Mini ON-OFF battery switch switches a single battery to a single load group.

MAIN FEATURESIgnition protection-safe for installation on board a petrol powered boat
Housing design allows surface or panel mounting
Insulating cover with snap-on sections protects back contact
TECHNICAL DETAILS

Switch positions: 2 - On/Off
Battery combination: No
Color: Red
Alternator Field Disconnect: No (Disconnect switch protects the diodes in the alternator when the switch is turned OFF with the engine running. If the disconnect switch is not used to protect the alternator, an LED can be connected to the AFD terminals to indicate when the battery switch is in any position but not OFF)
Maximum voltage: 48V DC
Terminal bolt torque: 13.56 Nm
Continuous charge current: 300 Amps.
Peak charge current: 500 amps
Starting Current 30 sec: 900 Amps The current required by the starter motor prior to cranking the engine. The starting current varies significantly during the starting cycle. Initially, there is a large surge of current required to overcome the inertia and compression of the engine. This surge can be two to four times the average starting current. The starting current is used for sizing batteries, cables, and battery switches.
Battery input: 1
Cable spacing for 4/0 AWG cable: 28.45mm
Recommended cable gauge: 4/0 AWG (120mm²)
Mounting holes: #10 screws
Clamp bolt size: 3/8" - 16 (M10)
Weight: 0.28 kg

More Less

Product category: Trim System/Trim Tabs

LENCO standard trim tabs for boat lengths from 4.3 m to 21 m.

LENCO electric trim tab system, unique quality. Electric trim cylinders with powerful DC motor, 12 volt, stainless steel trim tabs, easy installation because it is only installed from the outside, inside only the cable laying is required. No oil, no pump, guaranteed waterproof cylinders.
Electric, 12 Volt
Oil free - for the sake of the environment
CE certified
Easy, time and space saving installation
Waterproof and maintenance free
Solid Inox trim tabs (2.6 mm)
Trim tabs respond quickly, up/down in about 4 seconds and automatically go to the top position when turned off
Scope of delivery:
2 stainless steel trim plates
2 standard cylinders
2 upper holders, 2 lower holders, with screw set
6 m wiring,
Attention: The switches are not included in the delivery. You can choose between 5 different switches (197001-1, 1970000-3, 1970000-4, 1970000-1, 1970000-2)

More Less

About us

Company portrait

Welcome to Ferropilot, your competent partner around the recreational boating. Many of our products are also excellent for your vehicle, motorhome, 4x4 offroader or at home.
We have been supplying the specialist trade as a wholesaler for decades.
Ferropilot is part of the ELNA Group, a solution provider for commercial shipping and industry